Otherwise, it can not show video on themonitor and you have to use another monitor to adjust the resolution again. Please note: If you can view the video on your home monitor screen, do not change theresolution of NVR system on your monitor. When you see the video on another monitor, right click the mouse>System setup>-General setup&Screen setup, adjust the VGA resolution to click ok finally.Change to connect system with the first TV monitor, check if you can see the videoonce connected.ĭ.If step c is not working, connect to another monitor and adjust VGA resolution to1024hz60 and save the setting, then connect to first TV monitor. Don't forget to change the input to HDMI on a TV.Ĭ. On the monitor, make surethe 'input' is set to VGA.If no VGA cable, try another monitor with HDMI cable until getting video on the monitorscreen.

Askpeople who secured the WiFi (who set password) to enable the NVR to connect.Ī.The default output resolution of the NVR is 1280*1024, which may not be compatiblewith some screens.ī.Connect PC/TV monitor with NVR box by VGA cable first. If step a is not working, probably your router disabled DHCP or block new devicesfrom connecting.What DHCP does is: when router find new device connected, DHCP allocate new IP tothe device and connect it to the Internet.An easiest way to know if your router enables DHCP:When you connect a new device to your WiFi for Internet service (or a visitor/ friendwanted WiFi connection), does it require WiFi password only? If only passwordrequired, then your router has DHCP enabled if that requires not only password butalso some settings, then your router is secured from connecting new devices. Right click the mouse, navigate to System Setup > Network Setup > select DHCPand click Enable as shown in the figure below. Askpeople who secured the WiFi (who set password) to enable the NVR to connect.Answer:a.

Cms software dvr smonet download